iPECS UCP
Feature Description and Operation Manual Issue 1.3
331
5. IPECS PHONE
5.1 Answering Machine Emulation
Description
When a call is sent to a Voice Mailbox, the associated station can be assigned to notify you
and allow you to screen the call. Two methods of notification and call screening are provided,
Ring or Speaker mode.
In the Ring mode, you are notified by flashing of the AME (Answering Machine Emulation)
Flex button. You may press the Flex button to hear the caller as the voice message is stored.
In the Speaker mode, when the call is sent to the Voice Mailbox, the caller’s voice is
automatically broadcast over the speaker of your iPECS IP or LDP Phone.
You may terminate the screening leaving the caller in Voice Mail to record a message, talk
with the caller and record the conversation in the mailbox, or answer the call and disconnect
the Voice Mail.
Your iPECS IP or LDP Phone must be assigned with an AME Flex button for proper
operation.
Operation
iPECS IP & LDP Phones
Manual Mode:
To assign an {AME} button
[TRANS/PGM] + {FLEX} + “564” + “0” + [HOLD/SAVE]
Auto Mode:
[TRANS/PGM] + {FLEX} + “564” + “1” + [HOLD/SAVE]
1. Press the flashing {AME} button, the caller’s voice is broadcast over the station
speaker and stored in the Voice Mailbox.
To screen a call in the Manual mode
1. Press the illuminated [SPEAKER] button.
To stop the voice broadcast and leave the caller in Voice Mail
1. Press the illuminated [MUTE] button.
To talk with the caller and record the conversation in Voice Mail
1. Press the illuminated {AME} button, the caller is connected and the Voice Mail
disconnected.
To answer the call and cancel the voice message
Conditions
1. AME is supported only on iPECS IP and LDP Phones and an {AME} Flex button
To Next Page
Loading...
