iPECS UCP - 3 Intercom; Barge-In

iPECS UCP
Feature Description and Operation Manual Issue 1.3
270
3. INTERCOM
3.1 Barge-In
Description
Barge-in permits authorized extensions to intrude into other existing outside or intercom calls.
When you intrude on an existing call, a Conference is established with you as the supervisor
and the parties on the existing call.
Barge-in from your phone is assigned for one of three operating modes:
(0) – Barge-in is disabled.
(1) – Barge-in Monitor mode: the intruding station can listen only.
(2) – Barge-in Speech mode: the intruding station hears the conversation and may
join the conversation to speak to the other parties.
Operation
iPECS IP & LDP Phones w/3-Soft buttons
1. Call the busy station and receive busy tone.
To Barge-in in the Monitor mode
2. Press the [MONITOR]Soft button. You will need to use the right Navigation button
to display the Monitor selection.
3. Warning tone is sent to the connected parties and you are connected to the call in
a “listen-only”, monitor mode.
1. Call the busy station and receive busy tone.
To Barge-in in the Speech mode
2. Press the [MONITOR]Soft button. You will need to use the right Navigation button
to display the Monitor selection.
3. Warning tone is sent to the connected parties and you are connected to the call in
a “listen-only”, monitor mode.
4. If Barge-in Speech mode is assigned, press the [JOIN]Soft button to join the
conversation. The parties receive intrusion tone and you connect to the call.
5. To terminate the call and return all parties to idle, press the [DROP]Soft button.
1. Hang-up the phone.
To exit Barge-in
Conditions
1. This feature is only supported for iPECS IP and LDP Phone models with 3-soft
buttons.