iPECS UCP
Feature Description and Operation Manual Issue 1.3
269
Operation
Conditions
Operation of this feature is automatic based on the maximum outgoing CO calls allowed for
the Zone.
1. If the maximum outside calls for the Zone Attributes is set to “0”, the number of
outgoing calls for the Zone is not limited.
2. When a Zone reaches the defined maximum outgoing calls, you will receive error
tone and the display “OUTGOING CALL LIMIT OVER” when attempting an outside
call.
3. Calls placed from a device in a Zone to a Networked system are considered
outgoing outside calls for the Zone and will be limited by the outgoing call limit
defined for the Zone.
4. Emergency calls are counted as an outgoing outside call however, the Emergency
call is always allowed.
Programming
To Next Page
Loading...
