iPECS UCP - 5.19 Save Number Redial (SNR)

iPECS UCP
Feature Description and Operation Manual Issue 1.3
359
5.19 Save Number Redial (SNR)
Description
The last dialed number on an outside call may be stored (up to 48 digits) in a buffer for future
redial. This number is saved in memory until you request a new number be stored. Numbers
dialed for subsequent calls do not affect the Save Number buffer.
Operation
iPECS IP & LDP Phones
1. After dialing and before hanging up, press [SPEED] button twice.
To save a dialed number, after dialing the number on an outside call on the LDP phones
1. After dialing and before hanging up, press the right Navigation button, then the
next 3-Soft button menu displays.
To save a dialed number using the LIP-8000/8000E/9000 series menu
2. Press the [SAVE] soft button.
1. Lift the handset or press the [SPEAKER] button.
To dial a saved number
2. Press the [SPEED] button.
3. Dial “#”.
1. Press the [DIR] soft button.
To dial a saved number using the LIP-8000/8000E/9000 series menu
2. Press the [SPEED] soft button.
3. Dial “#”.
Conditions
1. The saved number can be a maximum of 48 digits.
2. Dialing the saved number will automatically seize the outside Line that was used
for the original call. If the Line is busy, a Line from the same group will be selected
and the saved number dialed. If all Lines from the group are busy, you will receive
the All Lines busy tone and may queue.
3. To erase a Save Number Redial, prior to dialing a number use the Save Number
procedure, this will erase the Save Number Dial buffer.
4. If there is no {LINE} button available at the phone, the call will be presented on a
{POOL}, or {LOOP} button.
5. Save Number Redial is protected from power failure.
6. Manually dialing a Flash during an outside Line will cause only those digits after
the Flash to be stored and re-dialed as the Save Number Redial.
Programming