iPECS UCP - 3.3 Intercom (ICM) Call

iPECS UCP
Feature Description and Operation Manual Issue 1.3
273
3.3 Intercom (ICM) Call
Description
A non-blocking ICM is available to all stations in the system. You may place an intercom call
to other stations in the system by dialing applicable digits as defined in the Station Numbering
Plan.
Operation
iPECS IP & LDP Phones
1. Lift the handset or press the [SPEAKER] button to receive ICM dial tone.
To place an intercom call
2. Dial station number or press the{DSS/BLF} button.
3. For ring-back tone, await answer or, for Intercom splash-tone, speak and await
answer.
SLT
1. Lift the handset to receive ICM dial tone.
To place an intercom call
2. Dial the station number.
3. For ring-back tone, await answer or, for Intercom splash-tone, speak and await
answer.
Conditions
1. Intercom dial tone will time-out if action is not taken within Dial-Tone Time or if the
time between digits exceeds the Inter-digit Timer. Error tone is received should a
time-out occur.
2. ICM Dial tone is removed after dialing the first digit.
3. If the called station is busy, Intercom Busy tone is provided by the system. You
may disconnect from the call or activate a feature such as Message Wait/Callback
prior to the time-out.
4. With your iPECS IP and LDP Phone, you can place consecutive Intercom calls
without the need to regain ICM dial tone (no need to hang-up) between calls;
simply press another {DSS/BLF} button.
5. An Intercom call to a station in the HF answerback or Voice Announce mode (H or
P Intercom Signaling Mode) is not considered answered unless the called user lifts
the handset or presses the [SPEAKER] button (goes off-hook).
Programming
STATION DATA
Common Attributes

Prime Line
SYSTEM DATA
System Timers

ICM Dial Tone Timer, Inter Digit Timer