iPECS UCP - 2.2 Account Code

iPECS UCP
Feature Description and Operation Manual Issue 1.3
4
2.2 Account Code
Description
You may allow tracking of specific calls by entering a non-verified variable length (up to 12
digits) identifier for a call. The identifier or “Account Code” is output as part of the Station
Message Detail Record (SMDR) for the call as discussed in Section 2.73. This is often used
to allocate call costs to a specific account or client.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “84” + [HOLD/SAVE]
To assign a Flex button for {ACCOUNT CODE} operation
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “84” + Account code (up to 12 digits) +
[HOLD/SAVE]
To assign a Flex button for {ONE-TOUCH ACCOUNT CODE} operation
1. Lift the handset or press the [SPEAKER] button.
To enter an Account Code using an {ACCOUNT CODE} button prior to placing a call
2. Press the {ACCOUNT CODE} button.
3. Dial the Account Code (up to 12 digits).
4. Press “*”, Intercom dial tone is heard.
5. Place the outside call as normal.
Or,
1. Lift the handset or press the [SPEAKER] button.
2. Press the {ONE-TOUCH ACCOUNT CODE} button.
3. Place the outside call as normal.
1. Press the {ACCOUNT CODE} button.
To enter an Account Code using an {ACCOUNT CODE} button during a call
2. Dial the Account Code (up to 12 digits).
3. Press “*”.
Or,
1. Press the {ONE-TOUCH ACCOUNT CODE} button.
SLT
1. Lift the handset.
To enter an Account Code prior to placing a call
2. Dial the Flex Numbering Plan code “550”.
3. Dial the Account Code (up to 12 digits).
4. Press “*”.
5. Place the outside call as normal.