iPECS UCP
Feature Description and Operation Manual Issue 1.3
397
6.12 Disable Outgoing Line Access
Description
The System Attendant can place outside Lines out-of service, disabling outgoing calls on the
Line. This is normally done should an undetected fault in the carrier or system circuit interrupt
service over the Line. Incoming calls continue to be processed normally.
Operation
System Attendant
1. Press the [TRANS/PGM] button.
To disable/enable Outgoing Line access (toggle)
2. Dial “072”, the Isolate Line Fault code.
3. Press the {Line} button of the line(s) to be disabled, confirmation tone is heard and
the status for the selected Line(s) is changed.
Conditions
1. The System Attendant may disable a busy Line. The feature will take effect after
the desired Line goes to idle.
2. Once the Line is disabled, all Attendant appearances for the disabled Line will
flutter at 240 ipm, other stations will indicate the Line as busy and the LED is ON.
3. The outside Line status is stored in battery-protected memory in case of a power
failure.
4. Multiple Lines may be enabled/disabled without redialing the Isolate Line Fault
code. Confirmation tone is heard after each Line is enabled/disabled.
5. When the system detects a fault on a Line, the Line is disabled for outgoing access
automatically.
6. Incoming calls on a disabled Line will continue to operate normally.
Programming
To Next Page
Loading...
