iPECS UCP
Feature Description and Operation Manual Issue 1.3
393
6.10 Day/Night/Timed/Scenario Ring Mode
Description
The system clock automatically controls the Ring Mode. Ring assignments are applied based
on the time of day and day of week. Four modes of ring (Ring Assignments) are provided
Day, Night, Timed and Scenario.
The Attendant controls the system Ring Service mode changing from Auto Service Mode to
Day, Night, Timed or Scenario service mode. Based on the service mode selected, different
ring assignments, COS (Class of Service) and answering privileges are invoked for the
system users.
Operation
System Attendant
1. Press the [DND] button.
To change Day/Timed/Night Ring Mode manually
2. Dial “1”~”5” to select the desired mode (1: Day mode, 2: Night mode, 3: Timed
mode, 4: Auto Service mode, 5: Scenario mode).
3. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To set Day/Timed/Night Ring/Scenario Mode automatically (Auto Service Mode Control)
2. Dial the Attendant Station Program code “073” to set Auto Mode control.
Conditions
1. Only Attendants can change Day/Timed/Night/Scenario Ring Mode for the system
manually and program the Auto Ring Mode Selection Table (Weekly Time table).
2. Stations receive incoming ring for outside Lines based on the database
assignments and the system mode (Day/Night/Timed/Scenario) when the call
arrives.
3. When the Auto Ring Selection Table is programmed, the ring, COS (Class of
Service) and Line access mode are changed automatically based on the times
assigned in the table.
4. The System Attendant always has manual control of the system mode by
enabling/disabling the Auto Service Mode Control.
5. To employ the Scenario mode, scenarios must be assigned in the System Call
Routing program.
Programming
To Next Page
Loading...
