iPECS UCP
Feature Description and Operation Manual Issue 1.3
263
2.85 Wake-up Alarm, Standard
Description
The standard Wake-up Alarm feature allows you or an Attendant to set a Wake-up alarm or a
desired time to be alerted. When the time is reached, the system will signal your station with
an audible and, for iPECS IP and LDP Phones, a visual signal is provided in the LCD. The
alerting for the Wake-Up alarm will repeat based on the type selected when you assign the
alarm.
The alarms will repeat as follows:
Repeat Type Repeating
1 Alarm activates one time at the assigned date and time
4 Alarm will repeat daily
A System Announcement can be assigned to play as a Wake-Up announcement when you
lift the handset in response to the alarm signal. Each station can be assigned a different
Wake-Up announcement, which is recorded by the Attendant.
Operation
Attendant
1. Press the [TRANS/PGM] button.
To register a Wake-Up alarm
2. Dial “044”, the Attendant Set Wake Up code.
3. Dial the desired station range, for a single station, enter an “*” in place of the
second station number.
4. Dial the 2-digit hour and 2-digit minute for alerting.
5. For a daily (repeating alarm), dial “#”.
6. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To erase a Wake-Up alarm
2. Dial “045”, the Attendant Erase Wake-up code.
3. Dial the desired station range, for a single station, enter an “*” in place of the
second station number.
4. Press the [HOLD/SAVE] button.
iPECS IP & LDP Phones
1. Press the [TRANS/PGM] button.
To register a Wake-Up alarm
2. Dial “41”, the Set Wake-up code.
3. Dial the 2-digit hour and 2-digit minute for alerting.
4. For a daily (repeating alarm), dial “#”.
5. Press [HOLD/SAVE] button.
To Next Page
Loading...
