iPECS UCP
Feature Description and Operation Manual Issue 1.3
264
1. Lift the handset or press the [SPEAKER] button.
To stop the alarm notification
1. Press the [TRANS/PGM] button.
To erase a Wake-Up alarm
2. Dial “42”, the Erase Wake-up code.
3. Press the [HOLD/SAVE] button.
SLT
1. Lift the handset.
To register a Wake-Up alarm
2. Dial “561”, the SLT Programming code, confirmation tone is heard.
3. Dial “41”, the set Wake-up code.
4. Dial the 2-digit hour and 2-digit minute for alerting.
5. For a daily (repeating alarm), dial “#”.
6. Hook flash, conformation tone is provided.
1. Lift the handset.
To stop the alarm notification
1. Lift the handset.
To erase a Wake-Up alarm
2. Dial “561”, the SLT Programming code, confirmation tone is heard.
3. Dial “42”, the erase Wake-up code.
4. Hook flash, a conformation tone is provided.
Conditions
1. In cases where a remote device is installed, the time display in the remote terminal
is adjusted by the Device Zone assignment. Thus, the Wake-Up alarm time is
based on the time displayed on the phone and not the system time.
2. When receiving a Wake Up signal, lifting the handset will return MOH or a System
announcement that is recorded and assigned to play when responding to the
Wake Up alarm.
3. The Wake-Up alarm signal is the station ring signal with a 30 seconds ON and 90
seconds OFF cycle 3 times. If no action is taken by you to terminate the alarm, the
Attendant is notified with a display of the station number that did not respond.
4. Time must be entered in the Military 24-hour format (hh:mm).
5. The daily alarm will reset and repeat each day until erased (cancelled). The One-
time alarm will reset and cancel automatically.
6. A System announcement can be recorded and assigned to play when the user
responds to the wake up alarm.
Programming
To Next Page
Loading...
