iPECS UCP - 2.80.2.9 CO Transit-In

iPECS UCP
Feature Description and Operation Manual Issue 1.3
243
4. The iPECS does not check the status of the receiving destination; once forward is
activated, the receiving system is responsible for routing the call.
5. Incoming analog CO lines must provide Disconnect Supervision and the Open
Loop Detect timer must be set for proper operation.
6. Station calls may automatically forward using Preset Call Forward or may forward
to your integrated Voice Mailbox. If the Preset Call Forward timer is shorter than
the Call Forward No-Answer timer, calls will not forward over the network.
7. Network Call Forward ‘Follow-Me’ can only be deactivated at the original station.
8. Network Call Forward Follow-Me is only available when employing H.323/H.450
networking. When employing Qsig, Call Forward ‘Follow-me’ is not available over
the network.
9. For proper operation of Call Forward Follow-Me, all systems in the network must
employ the same type of Authorization codes.
10. Call Forward Follow-me is not available between networked systems.
Programming
NETWORKING DATA Net Basic Attributes
Net Supplementary Attributes
Net CO Line Attributes
Net Numbering Plan
Related Features
 Call Forward
 Authorization Codes (Password)
 DND (Do Not Disturb)
 DND - One Time DND
 Direct Inward System Access (DISA)
 Unsupervised Conference
 Dialing Restrictions
 Station Groups
 Station Speed Dial
 System Speed Dial
 Intercom Signaling Mode
 Call Forward, Preset
Hardware
2.80.2.9 CO Transit-In
Description
When a DID call is received by a networked system, the system will attempt normal DID call
routing. The ICLID table is examined, followed by the MSN table, then the defined DID