iPECS UCP
Feature Description and Operation Manual Issue 1.3
245
Operation
Conditions
Operation of Distributed Networking is automatic when configured.
1. To use CO Transit-Out, the networked system user must dial the CO transit-out
code; the CO Transit-Out service is not activated by pressing a CO Line button.
2. The Station COS of the networked system is applied for toll restriction.
3. For CO Transit-Out, any numbering sequence code can be assigned in
(Networking Data Net Numbering Plan Numbering Plan Code). If a conflict
exists between the System and Network Numbering Plans, the System Numbering
Plan has priority.
4. The terminating PSTN lines must be assigned as Networked PSTN CO lines in the
terminating system.
5. For proper operation of CO Transit-Out, the Network CO Line type and System
Usage must be assigned as PSTN.
6. While not recommended, a call may be routed to the terminating system through
an ancillary system when a direct network connection is not deployed between the
originating and terminating systems.
7. When enabled in the Net Numbering Plan, you must enter a valid Station or
System Authorization code for access. The associated COS is implemented for the
call.
8. The system, which terminates the call, will generate two SMDR records for the call,
the original incoming call from the station number and the transit-out call.
9. The station receives busy tone when a networking path is not available during
transit-out.
10. For Transit-out, the Attendant of the calling system must be permitted access to
the CO Lines.
Programming
NETWORKING DATA Net Basic Attributes
Net CO Line Attributes
To Next Page
Loading...
