iPECS UCP - 4. OUTSIDE (CO;IP)LINES; 4.1 Auto Fault Detection and Recovery

iPECS UCP
Feature Description and Operation Manual Issue 1.3
299
4. OUTSIDE (CO/IP)LINES
4.1 Auto Fault Detection and Recovery
Description
If the system detects a Line fault on a PRI Line or SIP Trunk, the Line/Trunk is placed in an
Out-Of-Service state and temporarily placed in the unused Line group. Upon recovery, the
system will automatically return the Line to in-service. An alarm signal is sent to notify the
System Attendant of the fault.
Operation
System
Attendant
Operation of Fault Detection and Recovery is automatic.
1. Dial “565”, the Alarm Rest code.
To terminate the alarm signal
Conditions
1. The “Unused” Line Group contains Lines that are not used or are temporally
blocked.
2. This feature is only available for E1, T1 and PRI Lines, and SIP trunks.
Programming
CO LINE DATA
Common Attributes

CO/IP Group
System Data Alarm Attributes Emergency Call Notify, DCOB Fault
Notify, SIP Registration Fault Notify
Related Features
 Outside Line Groups
Hardware