iPECS UCP
Feature Description and Operation Manual Issue 1.3
307
4.8 DID Line Digit Conversion
Description
When you place or receive an outside call, the digits you dial or the called Id are compared
with the Digit Conversion Table. If the dialed digits match an entry in the table, the digits are
converted as defined in the table. Within the table are 32 sub-tables with up to 200 entries of
up to 24digits for each sub-table.
Different conversion can be assigned for the same dialed number based on the system
service mode and LCR configuration. Conversion can also be limited to outside calls from a
station or an outside Line. The latter may be used in networked environments where a
system in the network employs Lines from another system to place a call.
Operation
Conditions
Digit Conversion is applied automatically according to programming.
1. Each CO Line is assigned to use a specific Digit Conversion Table.
2. There are two (2) special entries for configuring digit conversion:
X: Mask Digit, any digit is accepted
F: Ignore Digit
Programming
To Next Page
Loading...
