iPECS UCP
Feature Description and Operation Manual Issue 1.3
233
1. Lift the handset or press the [SPEAKER] button.
To place an intercom call to a networked station
2. Dial station number or press the {NET DSS} button.
3. Await answer.
SLT
1. Lift the handset to receive ICM dial tone.
To place an intercom call
2. Dial the station number.
3. Await answer.
Conditions
1. A {NET DSS} button LED indicates the status of the associated station.
2. The LCD will display the caller’s Name if Calling Name Identification Presentation
(CNIP) is enabled in the Networking parameters and the caller’s Name is assigned
in their local iPECS system.
3. If no idle path is available over the Network, you will hear error tone.
4. Network Intercom calls always signal in the Tone ring mode and are not subject to
Intercom Caller Controlled ICM Signaling.
5. If a network failure occurs, the system will place an outside call using the Alternate
Speed Dial bin assigned in the Network Numbering Plan that corresponds to the
called user. Note this is not a Distributed Network call and thus features associated
with Networking such as Call Back, are not available.
6. Network Intercom calls are subject to the CO Call Restriction Timer.
Programming
NETWORKING DATA Net Basic Attributes
Net CO Line Attributes
Related Features
Intercom (ICM) Call
Speed Dial
Hardware
2.80.2.2 Net Call Transfer
Description
An active call, internal or outside, can be transferred to other stations across the Distributed
Network. Calls can be transferred across the network employing screened or unscreened
transfer in the same manner as a transfer within a system and is transparent to the user.
To Next Page
Loading...
