iPECS UCP - Page 246

iPECS UCP
Feature Description and Operation Manual Issue 1.3
234
From a network perspective, the iPECS can use either the ‘Join’ or ‘Re-route’ signaling
method to complete a call transfer over the network. The Networking Transfer Mode assigns
the method that will be used and should be selected to match other systems connected in the
private network.
 Join—an additional connecting path is needed to transfer the call to another Station.
 Routing—a new connecting path is used to transfer the call (the old connecting path
of the transferring station will be cleared).
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + Station Number + [HOLD/SAVE]
To assign a {NET DSS} button
1. Press the [TRANS/PGM] button.
To transfer an active call with Screened Call Transfer
2. Dial the station to receive the transfer.
3. At answer, announce the call.
4. Hang-up to complete the transfer.
Or,
1. Press the {NET DSS} button for the desired station.
2. At answer, announce the call.
3. Hang-up to complete the transfer.
1. Press the [TRANS/PGM] button.
To transfer an active call with Unscreened Call Transfer
2. Dial the station to receive the transfer.
3. Hang-up to complete the transfer.
Or,
1. Press the {NET DSS} button for the desired station.
2. Hang-up to complete the transfer.
SLT
1. Momentarily depress the hook-switch.
To transfer an active call with, Screened Call Transfer
2. Dial the Station number to receive the transfer.
3. At answer, announce the call.
4. Hang-up to complete the transfer.
1. Momentarily depress the hook-switch.
To transfer an active call with Unscreened Call Transfer
2. Dial the Station number to receive the transfer.
3. Hang-up to complete the transfer.
Conditions
1. A {NET DSS} button LED indicates the status of the associated station.
2. iPECS UCP automatically determines the type of transfer, local or networked,