iPECS UCP
Feature Description and Operation Manual Issue 1.3
76
the conference.
2. If the system receives a disconnect signal and no internal parties remain in the
conference, the conference is terminated and all parties are disconnected. If an
internal party is still connected when a disconnect signal is received, the
connection to remaining parties is maintained.
3. The normal Hold Recall process is applied to a conference on hold using the
Unsupervised Conference recall Timer for recall timing.
4. If while setting up a conference, system error tone is received, the initiator must
press the [CONF] button to regain Intercom dial tone; a SLT user must hook-flash.
5. A station that is busy, in DND or other non-idle state cannot be added to a
conference.
6. A SLT user can establish a 3-party conference only, but can be a member of other
multi-party conferences.
7. An MCIM is required to support 32-party conferences. With the MCIU, the number
of parties in the conference cannot exceed the number of MCIU channels (6 to 18).
Refer to the iPECS UCP Hardware Description and Installation Manual for MCIU
capacities. Note the capacity of the MCIU is reduced by approximately 1/3 when
transcoding of complex Codecs is needed.
Programming
Related Features
Automatic Speaker Select
Hold Recall
Unsupervised Conference
Broker Call
Conference Room
Hardware
MCIU or MCIM for more than 3-party conference
2.22.5 Unsupervised Conference
Description
Using your iPECS IP or LDP Phone, you may establish a conference with external parties
and exit the conference while allowing the external parties to converse privately without the
system supervising the connection through your phone. In this case, the system monitors the
outside Lines to determine if either party disconnects. In addition, the Unsupervised
Conference timer is initiated when an Unsupervised Conference is established. Fifteen
seconds prior to expiration of the timer, a Warning Tone is provided and at expiration, the call
disconnects.
To Next Page
Loading...
