iPECS UCP - 6.17 Intrusion

iPECS UCP
Feature Description and Operation Manual Issue 1.3
391
6.9 Call Forward, Off-Net
Description
The System Attendant can forward incoming outside calls to a remote “Off-Net” location.
Calls forward via a Speed Dial bin. When a call is received, the system will automatically
place a call using the Speed Dial number, dialing the number and connecting the incoming
call in an Unsupervised conference.
Operation
System Attendant
1. Lift the handset or press the [SPEAKER] button.
To activate Off-Net Call Forward
2. Press the [FWD] button.
3. Dial ‘5’, the Off-Net Forward feature code.
4. Dial the outside Line access code of the Line to forward.
5. Dial the Speed Dial bin to use to place the outgoing (Off-Net) call, the LED of any
Off-Net forwarded outside Line button at the Attendant stations will flutter at a rate
of 240 ipm while active.
1. Lift the handset or press the [SPEAKER] button.
To deactivate Off-Net Call Forward
2. Press the [FWD]button.
3. Dial “5”, Off-Net Forward code.
4. Dial the outside Line access Code.
5. Dial ‘#’.
Conditions
1. The System Attendant can forward any Line, Line Group or all outside calls using
the appropriate Line access code. In addition, a Flex button assigned to a Line or
group may be employed in place of the Line access code to forward calls.
2. The conditions of the Unsupervised conference feature apply.
3. The conditions of the Call Forward Off-Net feature apply.
4. When enabled, calls that forward Off-net will receive the Off-Net forward prompt.
5. When enabled, Lines that forward Off-net may receive DTMF tones as the Off-Net
call is placed.
6. To utilize Off-net forward of incoming calls on analog CO lines to another analog
CO line, a valid Open Loop Detect Timer should be assigned for the analog CO
lines. This is to prevent CO line lock up in case the analog CO lines do not provide
proper disconnect signals for the system to detect.
7. To enable this feature, Day/Night/Timed COS of DISA COS (PGM 166) must be
set on the available value to allow the CO line (ex. The value is 1).