iPECS UCP - Traffic Analysis

iPECS UCP
Feature Description and Operation Manual Issue 1.3
252
2.82 Traffic Analysis
Description
The iPECS monitors, stores and periodically or upon request outputs various traffic statistics
covering system resources. The output from the system can be used to:
 Monitor and evaluate system performance
 Observe usage trends and recommend possible corrective actions,
 Determine possible trunk problems, i.e. blocking level too high, and/or,
 Recommend system upgrades
Attendants enable Periodic Reporting. Once enabled, the system continues to monitor and
output the requested report until Periodic Reporting is disabled. On-demand reports selected
by the System Attendant are output only upon request. The Traffic Report is sent to the
defined system RS-232 or TCP port.
System resources covered by Traffic Reports are:
 Attendant Traffic Report
 Call Summary Report
 Hourly Call Report
 H/W Unit Usage Summary Report
 CO Summary Report
 Hourly CO Report
Summary Traffic Reports cover one of five Analysis periods selected at time of print:
 Today’s peak activity hour (within 24 hours)
 Yesterday’s peak activity hour (24 hours prior to Today’s activity)
 Last hour activity
 Today’s total activity
 Yesterday’s total activity
Operation
System Attendant
1. Press the [TRANS/PGM] button.
To print the All Periodic Traffic Report
2. Dial “0122”, the All Periodic report code.
3. Dial 4 digits (HH – HH).
4. Select Analysis Period (‘1’-‘5’).
5. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To cancel the periodic All Summary Report
2. Dial “0123”, the cancel All Summary report code.
3. Press the [HOLD/SAVE] button.