iPECS UCP - 2.8 Auto Called Number Redial (ACNR)

iPECS UCP
Feature Description and Operation Manual Issue 1.3
42
2.8 Auto Called Number Redial (ACNR)
Description
This feature allows you to request and have the system retry a busy or no answer external
call until the call is connected or the feature is cancelled.
Operation
iPECS IP & LDP Phones
1. Press the [REDIAL] button.
To activate ACNR while receiving busy, no answer
2. Hang-up handset, or press [SPEAKER].
1. Press flashing [REDIAL] button.
To cancel ACNR while idle
1. Lift the handset or press the [MUTE].
To cancel ACNR during an ACNR attempt
SLT Phone
1. Place the outside call as normal.
To activate ACNR while receiving busy, no answer
2. If the called party is busy or does not answer, press and release the hook-switch,
intercom dial tone should be heard.
3. Dial “58#”, the ACNR code.
4. Wait Off-hook until the call is answered.
System
1. The system initiates the ACNR process, starting the ACNR Pause Timer.
2. At expiration of the timer, the system activates the station’s speakerphone with the
microphone in the mute mode.
3. The system attempts the previous call.
4. When the called party answers, the user may answer by lifting the handset or
pressing the [MUTE] button to communicate with called party.
Conditions
1. Four timers and a retry counter can be programmed.
ACNR Pause Time Time allowed between ACNR attempts.
ACNR Delay Timer
At expiration of Pause Timer, if no Line is available,
the system will wait for delay timer before
attempting to access a Line.
ACNR Tone Detect After dialing, the system will abandon the attempt if