iPECS UCP - Station Call Coverage

iPECS UCP
Feature Description and Operation Manual Issue 1.3
211
2.74 Station Call Coverage
Description
The Call Coverage feature permits your iPECS IP or LDP Phone to receive ring and answer
calls directed to a covered station. This feature is generally employed to allow a Secretarial
answering position to cover calls to other stations. When a covered station rings, the
{CALLCOVERAGE} button LED will flash and the covering station may receive ring
(immediate or delayed) for the call. The covering station can answer the call using the {CALL
COVERAGE} button, terminating ring at other stations. Once answered, the LED of {CALL
COVERAGE} buttons for the station at other covering stations will extinguish.
Operation of this feature requires a {CALL COVERAGE} button at the covering iPECS IP or
LDP Phone and the covered station must activate call coverage. A station can have multiple
Call Coverage buttons each covering a different station and multiple stations can have a Call
Coverage button for a given station.
Call Coverage has several options, as below that are configured in the system database.
 Call Coverage On Busy
 Call Coverage Through Mobile
 Call Coverage Wake-Up call
 Call Coverage Ring and Delay Ring
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + “76” + covered Station number + [HOLD/SAVE]
To assign a {CALL COVERAGE} button at the covering station
1. Press the [TRANS/PGM] button.
To activate Call Coverage at the covered station
2. Dial “141”, the Call Coverage code.
3. Dial “1” to enable or “0” to disable Call Coverage.
1. Press the [TRANS/PGM] button.
To assign ring for a {CALL COVERAGE} button
2. Dial “142”, the Call Coverage Ring code.
3. Dial the delay in ring cycles (“0”-“9”).
4. When a covered station receives a call, the covering station will receive the
following display:
CALL FOR STA xxxx
FROM yyyy time
Conditions
1. An iPECS IP or LDP Phone user may cover for a SLT or other stations. However,