iPECS UCP - 2.20.2 Call Transfer, Station

iPECS UCP
Feature Description and Operation Manual Issue 1.3
64
3. If, during the transfer to an external party, you press the outside Line of the original
call, the outgoing call is disconnected and the original call is connected to your
phone.
Programming
STATION DATA
Common Attributes

Off-Net Forward
SYSTEM DATA System Attributes Off-Net Prompt Usage, CO to CO
Unsupervised Conference Time Extension
System Timers Unsupervised Conference Timer, Transfer
Recall Timer
Related Features
 Hold Recall
 Call Transfer, Station
 Unsupervised Conference
Hardware
2.20.2 Call Transfer, Station
Description
After answering an outside call, you can send the call to another station in the iPECS system.
Calls can be transferred announcing the call (screened) or without an announcement
(unscreened).
When a call is transferred, the Transfer Recall Timer is initiated. If the timer expires before
the call is answered, the Hold Recall process is initiated.
A Flex button on iPECS IP and LDP Phones can be assigned for the DSS/BLF (Direct station
Selection/Busy Lamp Field) function, which allows One-button Transfer.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + Station Number + [HOLD/SAVE]
To assign a {DSS/BLF} button
1. Press the[TRANS/PGM] button.
To transfer an active call with Screened Call Transfer
2. Dial the station to receive the transfer.
3. At answer or splash tone, announce the call.
4. Hang-up to complete the transfer.