iPECS UCP - Page 77

iPECS UCP
Feature Description and Operation Manual Issue 1.3
65
Or,
1. Press the {DSS/BLF} button for the desired station.
2. At answer or splash tone, announce the call.
3. Hang-up to complete the transfer.
1. Press the[TRANS/PGM] button.
To transfer an active call with Unscreened Call Transfer
2. Dial the station to receive the transfer.
3. Hang-up to complete the transfer.
Or,
1. Press the {DSS/BLF} button for the desired station.
2. Hang-up to complete the transfer.
SLT
1. Momentarily depress the hook-switch.
To transfer an active call with, Screened Call Transfer
2. Dial the Station number to receive the transfer.
3. At answer or splash tone, announce the call.
4. Hang-up to complete the transfer.
1. Momentarily depress the hook-switch.
To transfer an active call with Unscreened Call Transfer
2. Dial the Station number to receive the transfer.
3. Hang-up to complete the transfer.
Conditions
1. The transferring station may camp a call on to a busy station.
2. The LED of a {LOOP} or {POOL} button will display the status of an outside call
until the station no longer has call supervision i.e.; the call is successfully
transferred.
3. To prevent Toll abuse, outside Lines without an active call (either incoming or
dialed digits on outgoing) cannot be transferred.
4. For outgoing calls on analog Lines, the system will monitor the Line for dial tone to
prevent Toll abuse.
Programming
STATION DATA
Common Attributes

Ringing Line Preference
SYSTEM DATA
System Timers

Transfer Recall Timer
Related Features
 Hold Recall
 Call Transfer, CO/IP
 Call Waiting/Camp-On
 Station Flexible Buttons
Hardware