iPECS UCP
Feature Description and Operation Manual Issue 1.3
232
Intercom call (Station to Station Calling)
In addition, other features and functions, as detailed in the following sections, are available to
you as part of the distributed network environment.
Operation
Conditions
Operation of Distributed Networking is automatic when configured.
1. To use the networking features, the software lock-key installation is required. To
obtain a lock-key, contact your local Ericsson-LG Enterprise representative with
the system serial number.
2. Each station must have a unique station number of up to eight (8) digits, which is
based on their local system Station Numbering Plan.
3. The Network Numbering Plan permits 251 entries, allowing up to 251 iPECS
systems to be in a single distributed network environment.
4. The alternative route employs a Speed Dial number to place a call and is not a
Networked call. Thus, the Distributed Control Network features do not apply.
Programming
NETWORKING DATA Network Basic Attributes
Network Supplementary Attributes
Network CO Line Attributes
Network Numbering Plan
Related Features
Hardware
2.80.2.1 Net Intercom Call
Description
You can place calls to stations connected to other networked systems. Station calls across
the network are always terminated in the Tone Ring Intercom Signaling mode. Station calls
are placed in the normal manner by dialing the desired station number or pressing a {Net-
DSS} button.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + Station Number + [HOLD/SAVE]
To assign a Flex button as a {NET DSS} button
To Next Page
Loading...
