iPECS UCP
Feature Description and Operation Manual Issue 1.3
244
number conversion is completed. The system does a look-up in the Flexible DID Table to
identify the destination. If the number is a station in a networked system, the system routes
the call to the destination over the appropriate network connection with CLI provided to the
called station.
Operation
Conditions
Operation of Distributed Networking is automatic when configured.
1. CO Transit-In calls are not subject to recall or time restrictions at the originating
system.
2. If no path is available over the network, the caller will receive busy tone.
3. The system, which originally received the call, will generate two SMDR records for
the call, the original incoming call and the transit-call to the destination station.
Programming
NETWORKING DATA Net Basic AttributesCNIP Enable, CONP Enable
Net Supplementary Attributes
Net CO Line Attributes
Related Features
Direct Inward Dialing (DID)
ICLID Call Routing
Multiple Subscriber Number (MSN)
Hardware
2.80.2.10 CO Transit-Out
Description
CO Transit-Out increases efficiency of Lines and reduces call costs by routing outgoing calls
to the nearest appropriate point in a network of systems. At one system you can dial the
appropriate Line access code for Lines in the remote system. Codes are assigned in the
Network Numbering Plan at both systems and digit repeating passes the dialed digits to the
remote system.
When you dial the code, the local system compares the digits with appropriate local
Numbering Plan codes then to the Network Numbering Plan codes to determine routing.
When the number is found in the Network Numbering Plan table, the call is routed to the
designated networked system. Any digits received are sent to the remote system for proper
routing.
To Next Page
Loading...
