iPECS UCP - 2.63 Outside Line Access

iPECS UCP
Feature Description and Operation Manual Issue 1.3
183
2.63 Outside Line Access
Description
Stations can access outgoing Lines, if allowed Line access in the System database. The
iPECS IP and LDP Phones may use flexible buttons assigned to access a specific Line or
Line group button for outgoing calls or a {LOOP} button.
Individual users may be allowed to assign Flexible buttons to access a Line or Line group.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “85” + [HOLD/SAVE]
To assign a {LOOP} button
[TRANS/PGM] + {FLEX} +” 89” + CO Group Number + [HOLD/SAVE]
To assign a {POOL} button
1. Lift the handset or press the [SPEAKER] button.
To place an outgoing outside call
2. Press desired {LINE}, {POOL} or{LOOP} button, or dial the Line or Line group
access code.
3. Dial the desired outside number.
1. Lift the handset or press the [SPEAKER] button.
To answer an incoming outside call
Or,
Press the flashing {LINE}, {POOL} or {LOOP} button; this will answer the call over
the speakerphone. You may lift the handset to speak privately.
SLT
1. Lift handset.
To place an outgoing outside call
2. Dial the CO line or Group access code.
3. Dial the desired number.
1. Lift handset.
To answer an incoming outside call
Conditions
1. When you dial “9”, the system will search the preferred Line Group for an idle Line,
if there is no idle Line then the system will search the 1st Line Group for an idle
Line. The system may continue the search through all Line Groups for an available
Line if “1
st
CO/IP Group Override” is enabled.
2. If not allowed access to a specific outside Line, you receive error tone when