iPECS UCP - Page 89

iPECS UCP
Feature Description and Operation Manual Issue 1.3
77
If enabled, either party in an Unsupervised Conference can extend the Unsupervised
Conference beyond the timer expiration. The party enters the Timer Extension feature code
and a digit“1” to “9” indicating the Timer extension multiplier. The system extends the timer
based on the dialed digit multiple of the Timer. For example, if the Unsupervised Conference
timer is 5minutes and the user dials the digit 4, the timer will extend to 20 minutes (4
multiplied by 5minutes).
Operation
iPECS IP & LDP Phones
1. Establish a conference with external parties as normal.
To set up an Unsupervised conference
2. Press the [CONF] button. The [CONF] button LED flashes to indicate the
Unsupervised Conference state.
1. Press the flashing [CONF] button.
To reenter the Unsupervised conference
Conference Party
1. Dial “# #”.
To extend the Unsupervised Conference from a connected party
2. Dial the Timer extension multiplier (“1”~”9”).
Conditions
1. The Unsupervised Conference Timer also applies to an external call placed by a
DISA line in the system.
2. An Unsupervised Conference will be terminated if the system receives a
disconnect signal or the Unsupervised Conference Timer expires.
3. An Unsupervised Conference will not recall the user.
Programming
SYSTEM ID
&NUMBERING PLANS
Flexible Numbering Plan Unsupervised Conference Timer
Extension Code
STATION DATA
Common Attributes

Off-Net Forward
SYSTEM DATA System Attributes  CO to CO Unsupervised Conference
Time Extension
System Timers

Unsupervised Conference Timer
Related Features
 Direct Inward System Access (DISA)
 Multi-Party Voice Conference
Hardware
 iPECS IP or LDP Phone