iPECS UCP
Feature Description and Operation Manual Issue 1.3
191
1. Press the [TRANS/PGM] button.
To cancel active Display Messages for other stations
2. Dial “052”, Attendant Display Message Cancel code.
3. Dial the station range, for a single station dial the same station number twice.
4. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To enter a System-wide Custom Message
2. Dial “053”, the System-wide Custom Message program code.
3. Dial desired Message code (“11”-“20”).
4. Enter the Message contents, up to 24 characters.
5. Press the [HOLD/SAVE] button, confirmation tone is received, the new Custom
Message is stored and the station returns to idle.
Conditions
1. The iPECS UCP can automatically activate DND to internal callers when you
activate Pre-selected or Custom Text Message Display. Enabling P-Msg DND
activates DND when a Text Display Message is activated.
2. Only the System Attendant or Administrator can assign the contents of Custom
Messages 11-20.
3. The alphanumeric characters are displayed as they are entered; refer to Station
Speed Dial for entry procedures.
4. Display Message is cancelled if you activate DND or Call Forward.
5. Custom Text Display Messages and Display Message status are stored in non-
volatile memory to protect against loss during power failure.
6. The calling station must be an iPECS IP or LDP Phone with display to receive the
message.
7. SLTs are notified of an active Display Message with stutter dial tone. The iPECS
IP and LDP Phones will have a flashing [FWD] button when Text Display Message
is active.
8. Activating Text Display Message does not affect normal operation of the station.
9. Pre-defined Messages 01 to 04 and 06 to 08 permit you to input auxiliary
information such as time, date or number.
10. The Attendant station can activate Text Display Messages for other stations.
However, the Text Display Message feature is not available to an Attendant.
Programming
To Next Page
Loading...
