iPECS UCP
Feature Description and Operation Manual Issue 1.3
249
Operation
iPECS IP or LDP Phone
[TRANS/PGM] + {Flex Button} + Net Numbering Plan code for Page +
[HOLD/SAVE]
To assign a Flex button to access a Page Zone in Networked system
1. Lift the handset.
To Page a Networked system Zone
2. Dial the Network Paging code and Zone, or press a {NET PAGE ZONE} button.
3. If assigned, after the Page Warning Tone, make announcement.
4. Replace the handset to return to idle.
1. Press the[MESSAGE/CALL BACK] button.
To queue for a page when busy is received
2. Replace the handset, returning to idle.
SLT
1. Lift the handset.
To make a page
2. Dial the Network Paging code and Zone.
3. If assigned, after the Page Warning Tone, make announcement.
4. Replace the handset, to return to idle.
1. Dial “556”, the Call Back code.
To queue for a page when busy tone is received
2. Replace the handset returning to idle.
Conditions
1. The conditions such as Page Access, Page Time-out, etc. apply to Network
Paging.
2. A Network Page code must be programmed in Networking Data Net Numbering
Plan in the calling system.
3. A Network Page code and page destination must be programmed in Networking
Data Net Feature Code Table in the called system.
4. The Network Page destination can be Internal Page, External Page and All Call
Page.
5. You will hear error tone if there is no idle networking path or if the page destination
is invalid.
6. You can page within a networked system without lifting the handset.
Programming
NETWORKING DATA Net Basic Attributes
Net CO Line Attributes
Net Numbering Plan
To Next Page
Loading...
