iPECS UCP
Feature Description and Operation Manual Issue 1.3
339
1. Lift the handset or press the [SPEAKER] button to receive a dial tone.
To activate ICR Call Forward
2. Press the [FWD] button.
3. Dial the desired Call Forward code (0-4).
4. Dial “587”, the Station ICR activation code.
5. Replace the handset, return to idle.
1. Activate ICR Call Forward.
To activate/deactivate a Profile from your phone
2. Press the [TRANS/PGM] button and dial “26”, the Call Profile menu
or Log in to the Station Web portal.
3. Select the Call Profile Table desired (“0”: ICR or “1”-“3”: Call Profile 1-3).
1. Call to iPECS System (DISA CO Line).
To change the Call Profile while away from your phone
2. Dial “#” to access your Voice Mailbox.
3. Enter your Station Number and Authentication code.
4. Dial “7” to set call forward.
5. Enter “1” to set Station Call forward.
6. Enter “587”, the Station ICR Code.
7. Enter “Call Profile Number” (0:ICR Forward, 1-3: Call Profile 1-3).
Conditions
1. Call Profile Routing is available on digital and IP Lines only and is applied to
outside calls that are routed to your phone as a Transfer, DID or DISA call. Calls
that are assigned to Ring to your phone are not subject Call Profile Forward.
2. The conditions associated with Station ICR apply to Call Profile Routing.
3. It is recommended that any hunt group route be set as the last call profile
destination. Once a call is routed to a Hunt group, only the Hunt group routing is
followed and further Profile routing is ignored.
Programming
STATION DATA Common Attributes Call Forward
To Next Page
Loading...
