iPECS UCP
Feature Description and Operation Manual Issue 1.3
376
mode. When an external AA/VM system employs the in-band (DTMF) mode, Two-
Way Record is not available.
3. With the Feature Server or integrated VM, internal calls can be recorded as well as
external calls.
4. Use of this feature when the Two-Way Recording Warn Tone is disabled may be
interpreted as a violation of federal, state, or local laws, and an invasion of privacy.
Check applicable laws in your area before recording calls using this feature.
5. If a destination for the recording is not defined for the {RECORD} button, the
Automatic Talk Recording Destination defined in the VM Attributes under Station
Data is employed.
6. On-demand recording using a Voice Mailbox or hard drive records the call from the
point in time when the {Record} button is pressed. When using the IPCR server,
the entire call will be record as long as the {Record} button is pressed before the
call is terminated.
7. The UCS Client can record one call at a time and must be idle. While recording, if
the UCS Client places or receives a call, recording terminates.
8. When call recording begins, you and the connected party will receive a Call
Recording confirmation tone and the tone may repeat at intervals.
9. The UCS Client used for recording must be operating in a ‘Local’ mode not remote.
10. A third party SIP Voice Mail or recording server may be used to record calls. In this
case, the Recording Destination should be assigned with the Station group of the
SIP server.
11. When you activate call recording to an iPECS IPCR the entire call is recorded as
long as the call is active when you activate recording. It would be expected that
other SIP recording servers would provide similar On-demand recording.
12. The IPCR Agent Table in the iPECS UCP must be configured when using the
IPCR application or a third-party SIP recording server.
Programming
STATION DATA VM Attributes Two Way Record, Automatic Talk Recording
To Next Page
Loading...
