iPECS UCP - Page 66

iPECS UCP
Feature Description and Operation Manual Issue 1.3
54
13. Off-Net forward calls are not answered by the system until the system completes
dialing of the external call. The caller is then connected to the outgoing call.
14. If the Speed Dial number used in Off-Net Call Forward contains a Flash, only digits
prior to the Flash are dialed.
15. An unlimited number of stations may be set-up in a Call Forward chain, forwarding
calls from one station to the next. However, a station cannot forward calls to a
station already a part of the chain.
16. Calls to a Call Forward chain will progress as appropriate through the chain to the
last station. If the last station enters DND, outside calls revert to the previous
station while intercom calls receive DND tone.
17. No Answer forward employs the Station No Answer Forward Timer unless it is set
to zero in which case the System No Answer Timer is used.
Programming
STATION DATA Common AttributesCall Forward
Station Timer

Station Call Forward No Answer Timer
SYSTEM DATA
System Timers

Call Forward No Answer Timer
STATION GROUP
DATA
Station Group Attributes Allow Forward Member
Related Features
 Call Forward, Attendant
 Authorization Codes (Password)
 DND (Do Not Disturb)
 DND - One Time DND
 Direct Inward System Access (DISA)
 Unsupervised Conference
 Dialing Restrictions
 Station Groups
 Station Speed Dial
 System Speed Dial
 Intercom Signaling Mode
 Call Forward, Preset
 Station ICR(Individual Call Routing)
Hardware