Korg NAUTILUS Series

COMBINATION > Home 0–6: ARP DRUM
391
DRUM MIDI ch:
Output Ch [01...16, Gch]
This displays the MIDI channel used to transmit MIDI data
for the drum patterns set in each timbre.
The drum patterns play using the Program of the timbre that
is set to the same MIDI channel.
Scene1–4 Setup
Here we configure each of the arpeggiator and drum settings
for each scene.
There are two arpeggiators (A and B) in COMBINATION
mode, and two arpeggio patterns can be used
simultaneously.
Arppegio Pattern [P0...P4, A0000...A2047,
B000...B127]
Loop/1Shot
Latch
Drum Track/StepSeq select
Drum Track Pattern
More
Refer to PROGRAM mode for the respective settings. For
more information, see “Scene1–4 Setup” on page 18.
Output Ch [01...16, Gch]
Sets the MIDI output channel for each arpeggiator.
Out of the MIDI data transmitted from each arpeggiator, the
timbres that match the MIDI channels you set here will
sound.
Gch: The MIDI output channel will be the global MIDI
channel (GLOBAL 1–1a: “MIDI Channel”) for each
arpeggiator.
Thru By ARP Switch Off [On, Off]
This sets whether the MIDI data received by each
arpeggiator will be transmitted (sent through) to the timbre
via the MIDI channel specified in “Output Ch”, when the
arpeggiator function is off.
On (checked): When the arpeggiator function is off, the
MIDI data received by each arpeggiator will be transmitted
(sent through) to the timbre via the MIDI channel specified
in “Output Ch”.
Off (unchecked): When the arpeggiator function is off, the
MIDI data received by each arpeggiator will not be
transmitted to the timbre.
Timbre Zone Bypass [Off, On]
Sets whether to enable the key zone settings (???) and
velocity zone settings (???) of the timbres, for the phrases
and patterns of each arpeggiator.
On (checked): Bypasses the timbre key zone and velocity
zone settings for the phrases and patterns that are generated.
The various timbre settings will be ignored, and all
generated notes will sound.
Off (unchecked): Enables the timbre key zone and velocity
zone settings for the phrases and patterns that are generated.
Any notes generated that fall outside of the timbre’s key
zone or velocity zone will not sound.
Edit STEP SEQUENCE
For more information, see “Edit STEP SEQUENCE” on
page 20.
v 0–6: Page Menu Commands
• Compare →p.112
• Write Combination →p.433
• Exclusive Solo →p.113
• Copy From Program →p.433
• Add To Set List →p.113
• Copy External Scene →p.121
• Copy Scene →p.121
•Swap Scene →p.122
• Initialize Scene →p.122
•PAGE →p.126
•MODE →p.126