Korg NAUTILUS Series

COMBINATION mode
400
Timbre 01
X-Y Assign [Off, +X, –X, +Y, –Y]
This assigns an axis of the Ve ct or to control the Timbre’s
volume. See the diagram “X-Y Assign and Program
Volume,” below, for more details.
Off means that the X-Y position will not affect the Timbre’s
volume.
X-Y Assign and Program Volume
Center Volume [0, 25, 50, 75, 100%]
This sets the volume of Timbre 1 at the center point. It
applies only when Equal Amount, above, is set to Off.
The volumes at the extreme ends of the axis are fixed,
depending on the setting of the X-Y Assign parameter.
For instance, if X-Y Assign is set to –X, the Timbre will
always be at 100% volume on the left side, and 0% (silent)
on the right side.
This parameter applies only to the Combi X-Y Volume
control, and does not change the Program’s individual X-Y
Volume settings.
Timbre Center Volume, X-Y Assign = –X
Enable Program X-Y Volume [Off, On]
When this is turned On, the Program’s X-Y Volume control
will function as it does in PROGRAM mode, crossfading
between Oscillators 1 and 2. The crossfade will be controlled
by the Program’s X-Y Envelope and is not affected by the
Combi’s X-Y Envelope.
When this is turned Off, the Program’s X-Y Volume control
will be disabled.
Volume at Show Point [%]
Shows the volume at the current X-Y point selected in
“Show Point”.
Timbres 02–16
The parameters for Timbres 2–16 are identical to those for
Timbre 01, as described above.
v 1–5: Page Menu Commands
• Compare →p.112
• Write Combination →p.433
• Exclusive Solo →p.113
• Copy From Program →p.433
• PAGE →p.126
•MODE →p.126
+127–127 0
+X
0% 100%
+127–127 0
–X
100% 0%
Program volume increases
from left to right.
Program volume increases
from right to left.
+127
–127
0
+Y
0%
100%
+127
–127
0
–Y
100%
0%
Program volume increases
from bottom to top.
Program volume increases
from top to bottom.
Volume
50%
100%
0%
X-Y X-axis position
-127 0 +127
Center Volume Values: 100
75
50
25
0