SEQUENCER > Home 0–6: Recording Setup
459
If the signal distorts even after you turn down the analog
input gain, the settings of the internal effects may be
causing the distortion. Try turning down “(Input 1, 2)
Level” (0–8a) or adjusting the effect settings.
Name 1…4
Here you can specify the names of the regions and WAVE
files that will be created when you record audio tracks.
You can use up to eight characters.
If you check Take at the right, the take number will
automatically be input as the last two characters of the name.
For more information, see Tak e (below).
Take [Off, On]
On (checked): The take number specified by Take No. will
automatically be assigned as the last two characters in the
name of the region and WAVE files that are saved. The
number will automatically increment after recording. If you
are recording repeatedly, you can use the take numbers to
manage the separate recordings.
If Take is unchecked, you can input up to eight characters as
the file name. If it is checked, you can input up to six
characters.
Off (unchecked): The take number will not be included in
the name of the subsequently-recorded region and WAVE
files.
Take No. [00…99]
This specifies the take number that will be used if Tak e is
checked. After each recording, this number will
automatically increase by one from the previous take.
0–6d: Metronome Setup
Here you can make metronome settings.
Level [000…127]
Sets the volume of the metronome.
Output Bus [L/R, L, R, 1…4, 1/2…3/4]
Selects the output destination of the metronome sound.
L/R, L, R: Output from OUTPUT (MAIN) L/Mono and/or
R.
1…4, 1/2…3/4: Output from OUTPUT (INDIVIDUAL) 1–4
respectively.
Precount [Measure] [0…2]
Specifies the pre-count that will occur before recording
begins.
With a setting of 0, recording will begin the instant you press
the SEQUENCER START/STOP button (after first pressing
the SEQUENCER REC button).
v
0–6: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Rename Song →p.521
• Initialize Song →p.522
• Copy From Song →p.522
• Load Template Song →p.522
• Save Template Song →p.523
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
• GM Initialize →p.523
• Copy from Combi →p.525
• Copy From Program →p.525
• Stereo Pair →p.525
• Auto HDR/Sampling Setup →p.527
• Add To Set List →p.113
• Load required samples →p.114
•PAGE →p.126
•MODE →p.126
To Next Page
Loading...
Need help?
General
