GLOBAL > Wave Sequence 4–2: Step Parameter
669
Wave Sequence step Durations, Crossfade times, and Fade-In and Fade-Out shapes
4–2d: Command buttons
Insert
This command inserts the previously Cut or Copied step
before the current step.
Cut
This command removes the current step from the Wave
Sequence, and moves the subsequent steps forward. The
removed step can then be Pasted or Inserted into another
location, if desired.
Copy
This command copies current step. You can then Paste or
Insert the step into another location.
Paste
This command replaces the current step with the previously
Cut or Copied step.
Exp/Comp (Mode = Time)
This command appears only when the Mode is set to Time.
It brings up a dialog box, which allows you to expand or
compress all of the duration and crossfade times by a
specified percentage.
Duration Time dialog box
Expand/Compress [%] [0…100,000]
100% means the current duration and crossfade times.
Va lu es 99 and below make the times shorter, and values 101
and above make them longer.
/2 (Mode = Tempo)
This command appears only when the Mode is set to
Temp o . It cuts the step durations and/or Multiply Base Note
settings in half, so that 1/4 notes become 1/8 notes, 1/8 notes
become 1/16 notes, and so on.
x2 (Mode = Tempo)
This command also appears only when the Mode is set to
Temp o . It multiplies the step durations and/or Multiply
Base Note settings by two, so that 1/8 notes become 1/4
notes, 1/4 notes become 1/2 notes, and so on.
v
4–2: Page Menu Commands
• Compare →p.112
• Write Wave Sequence →p.690
• Remap MS/Sample Banks →p.125
•PAGE →p.126
•MODE →p.126
Volume
Time
Step 1
Duration
Step 1
Crossfade
Step 2
Crossfade
Step 2
Duration
Step 3
Duration
Step 4
Duration
Step 3
Crossfade
Step 4
Crossfade
Xfade In = Log Xfade Out = Exp Xfade In = Off
Xfade In = Lin Xfade Out = Log
Xfade Out = Off
To Next Page
Loading...
Need help?
General
