Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 235
Buttons
Add New MAC Entry: Clicking this button will add a new row to the table. This new row allows for adding a static
or sticky MAC address to a particular interface. When done, click the Apply button to save the changes to
running-config. Note that sticky entries are normally added automatically by learning on the interface.
Refresh: Click to refresh the page. Note that non-committed changes will be lost.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Messages:
Error: The <MAC, VLAN> is already installed on another interface
Error: MAC address must be a unicast MAC address
Port Security Static and Sticky MAC Addresses Example:
Port select dropdown: When adding a new MAC entry, select the desired port for the row in the table.
Type dropdown: When adding a new MAC entry, select the desired type for the row in the
table. Select Static or Sticky; see the descriptions above.
Messages:
Error: The <MAC, VLAN> is already installed on another interface
Error: Cannot add sticky entry on non-sticky interface

Lantronix SISPM1040 L3 Series Specifications

General

Brand	Lantronix
Model	SISPM1040 L3 Series
Category	Switch
Language	English