Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 237
State: Shows the current state of the port. It can take one of four values:
Disabled: No user modules are currently using the Port Security service.
Ready: The Port Security service is in use by at least one user module and is awaiting frames from
unknown MAC addresses to arrive.
Limit Reached: The Port Security service is administratively enabled, and the limit is reached.
Shut down: The Port Security service is administratively enabled, and the port is shut down. No MAC
addresses can be learned on the port until it is administratively re-opened by administratively taking the
port down and then back up on the "Configuration > Ports" page. Alternatively, the switch may be booted
or reconfigured in terms of Port Security.
MAC Count (Current, Violating, Limit): The three columns indicate the number of currently learned MAC
addresses (forwarding as well as blocked), the number of violating MAC address (only counting in Restrict mode)
and the maximum number of MAC addresses that can be learned on the port, respectively.
If no user modules are enabled on the port, the Current column will show a dash (-).
If Port Security is not administratively enabled on the port, the Violating and Limit columns will show a
dash (-).
Buttons
Auto-refresh: Check this box to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
To Next Page
Loading...
Need help?
General
