Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 244
Pending Requests : The number of RADIUS packets destined for the server that have not yet timed out or
received a response. This variable is incremented when a Request is sent and decremented due to receipt of a
Response, timeout, or retransmission.
Timeouts : The number of accounting timeouts to the server. After a timeout, the client may retry to the same
server, send to a different server, or give up. A retry to the same server is counted as a retransmit as well as a
timeout. A send to a different server is counted as a Request as well as a timeout.
IP Address : IP address and UDP port for the accounting server in question.
State : Shows the state of the server. It takes one of the following values:
Disabled : The selected server is disabled.
Not Ready : The server is enabled, but IP communication is not yet up and running.
Ready : The server is enabled, IP communication is up and running, and the RADIUS module is ready to
accept accounting attempts.
Dead (X seconds left) : Accounting attempts were made to this server, but it did not reply within the
configured timeout. The server has temporarily been disabled but will get re-enabled when the dead-time
expires. The number of seconds left before this occurs is displayed in parentheses. This state is only
reachable when more than one server is enabled.
Round-Trip Time : The time interval (measured in milliseconds) between the most recent Response and the
Request that matched it from the RADIUS accounting server. The granularity of this measurement is 100 ms.
A value of 0 ms indicates that there hasn't been round-trip communication with the server yet.
Buttons
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
Refresh : Click to refresh the page immediately.
Clear : Clears the counters for the selected server. The "Pending Requests" counter will not be cleared by this
operation.
Server select box: Dropdown to select the desired server to be displayed.
To Next Page
Loading...
Need help?
General
