Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 248
Other Info
This section contains information about the state of the server and the latest round-trip time.
Name
RFC4670 Name
Description
IP
Address
-
IP address and UDP port for the accounting server in
question.
State -
Shows the state of the server. It
takes one of these values:
Disabled
: The selected server is disabled.
Not
Ready: The server is enabled, but IP communication is
not yet up and running.
Ready
: The server is enabled, IP communication is up and
running, and the RADIUS module is ready to
accept
accounting attempts.
Dead
(X seconds left): Accounting attempts were made to
this server, but it did not reply within the configured timeout.
The server has temporarily been
disabled but will get re-
enabled when the dead
-time expires. The number of
seconds
left before this occurs is displayed in parentheses. This state
is only reachable when more than one server is enabled.
Round-
Trip Time
radiusAccClientExtRoundTripTime
The time interval (in milliseconds) between the most recent
Response and the R
equest that matched it from the RADIUS
accounting server. The granularity of this measurement is
100 ms. A value of 0 ms indicates that there hasn't been
round-trip communication with the server yet.
Buttons
Server Select box: At the dropdown select which RADIUS server’s information to display.
Auto-refresh: Check this box to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
Clear: Clears the counters for the selected server. The "Pending Requests" counter will not be cleared by this
operation.

Lantronix SISPM1040 L3 Series Specifications

General

Brand	Lantronix
Model	SISPM1040 L3 Series
Category	Switch
Language	English