Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 291
VLAN: The MA's primary VID. A primary VID of 0 means that all MEPs created within this MA will be created as
port MEPs (interface MEPs). There can only be one port MEP per interface. A given port MEP may still be
created with tags, if that MEP's VLAN is non-zero.
A non-zero primary VID means that all MEPs created within this MA will be created as VLAN MEPs. A given MEP
may be configured with another VLAN than the MA's primary VID, but it is impossible to have untagged VLAN
MEPs.
CCM Interval: The CCM rate of all MEPs bound to this Service.
TLV option select:
Sender Id: Default Sender ID TLV format to be used in CCMs generated by this Service.
None: Do not include Sender ID TLVs.
Chassis Enable: Sender ID TLV and send Chassis ID (MAC Address).
Manage Enable: Sender ID TLV and send Management address (IPv4 Address).
ChassisManage Enable: Sender ID TLV and send both Chassis ID (MAC Address) and Management
Address (IPv4 Address).
Defer: Let the Domain configuration decide if Sender ID TLVs will be included.
Port Status: Include or exclude Port Status TLV in CCMs generated by this Service or let higher level determine.
Disable: Do not include Port Status TLVs.
Enable: Include Port Status TLVs.
Defer: Let the Domain configuration decide if Port Status TLVs will be included.
Interface Status: Include or exclude Interface Status TLV in CCMs generated by this Service or let higher level
determine.
Disable: Do not include Interface Status TLVs.
Enable: Include Interface Status TLVs.
Defer: Let the Domain configuration decide if Interface Status TLVs will be included.
Org. Specific: Exclude Organization-Specific TLV in CCMs generated by this Service or let higher level
determine.
Disable: Do not include Organization-Specific TLVs.
Defer: Let the Domain configuration decide if Organization-Specific TLVs will be included.
Buttons
Auto-refresh: Check this box to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
Add New Entry: Click to add a new access management entry.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Messages:
Service cannot be empty
JSON RPC Error. (Invalid MA name length. It must be exactly 13 characters long)
JSON RPC Error. (Invalid params)

Lantronix SISPM1040 L3 Series Specifications

General

Brand	Lantronix
Model	SISPM1040 L3 Series
Category	Switch
Language	English