Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 304
Wait to restore: I.
Do not revert: J.
Exercise Working: K.
Exercise Protecting: L.
Reverse request Working: M.
Reverse request Protecting: N.
Signal degrade Working: P.
Signal degrade Protecting: Q.
Defect state, Working, Protection: The possible values of this field are shown below:
ok: The port defect state is OK
sd: The port defect state is Signal Degrade
sf: The port defect state is Signal Fail
TxAps, RxAps – Request: The possible transmitted or received APS request according to G.8031, Table 11-1.
nr: No Request.
dnr: Do Not Revert.
rr: Reverse Request.
exer: Exercise.
wtr: Wait-To-Restore.
ms: Manual Switch.
sd: Signal Degrade.
sfW: Signal Fail for Working.
fs: Forced Switch.
sfP: Signal Fail for Protect.
lo: Lockout.
TxAps, ReSignal: Transmitted requested signal according to G.8031 figure 11-2.
TxAps, BrSignal: Transmitted bridged signal according to G.8031 figure 11-2.
RxAps, ReSignal: Received requested signal according to G.8031 figure 11-2.
RxAps, BrSignal: Received bridged signal according to G.8031 figure 11-2.
Dfop: Dfop is "Failure of Protocol defect" and the presence of a defect is indicated by up: no defect, down: defect.
CM: Configuration Mismatch (received APS PDU on working interface within last 17.5 seconds).
PM: Provisioning Mismatch (far and near ends are not using the same mode; bidir only)
NR: No Response (far end hasn't agreed on 'Requested Signal' within 50 ms; bidir only)
TO: Time Out (near end hasn't received a valid APS PDU within last 17.5 seconds; bidir only)
SMAC: Source MAC address of last received APS PDU or all-zeros if no PDU has been received.
TxCnt: Number of APS PDU frames transmitted.
RxCnt, Valid: Number of valid APS PDU frames received on the protect port.
RxCnt, Invalid: Number of invalid APS PDU frames received on the protect port.
Buttons
Auto-refresh: Check this box to refresh the page automatically every 3 seconds.
Refresh: Click to manually refresh the page immediately.
To Next Page
Loading...
Need help?
General
