Lantronix SISPM1040 L3 Series - Page 470

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 470
Hover the mouse cursor over a column in the table to display its specific parameters:
→
Message: “Traffic Monitor feature is only available on master switch” added at FW v8.40.1523.
Meaning: You clicked on “Traffic Monitor” at DMS > Traffic Monitor, but this switch is not the DMS Controller
(Master) Switch.
Recovery: Either make this switch the DMS Controller (Master) Switch or use the designated DMS Controller
(Master) Switch for traffic monitoring. See “DMS Information page” on page 450.