Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 477
Web UI Messages
Message: Interface xx not using DHCP
Meaning: The Interface being configured does not have DHCP enabled and configured.
Recovery: 1. Click the OK button to clear the webpage message. 2. Enable and configure DHCP for the interface being
configured.
Message: ‘DHCP Per Port IP range (192-168-1.80 - 192-168-1.99) is not equal to switch port number excluding uplink ports
(10)
Meaning: The IPv4 IP address range entered for the DHCP Per Port function was invalid.
Recovery: 1. Click the OK button to clear the webpage message. 2. Re-configure DHCP Per Port. See the DHCP Per Port
Mode Configuration section above.
Message: ‘DHCP Per Port IP range (192-168-1.70 - 192-168-1.85) includes interface IP Address (192.168.1.77)
Meaning: The IPv4 IP address range entered for the DHCP Per Port function was invalid.
Recovery: 1. Click the OK button to clear the webpage message. 2. Re-configure DHCP Per Port.
See the DHCP Per Port Mode Configuration section above. On the screen below, the range should be something like 192-
168-1.80 - 192-168-1.85 to be valid.
Message: The value of ‘DNS Server’ must be a valid IP address in dotted decimal notation (‘x.y.z.w’).
Meaning: You entered an invalid IP address for the DNS Server being configured.
Recovery: 1. Click the OK button to clear the webpage message. 2. Enter a valid IP address in the format x.y.z.w per the on-
screen restrictions.
Message: ‘DHCP Interface VLAN ID’ must be an integer value between 1 and 4095.
Meaning: You entered an invalid VLAN ID for the DHCP Interface.
Recovery: 1. Click the OK button to clear the webpage message. 2. Enter a valid VLAN ID for the DHCP Interface (1-4095).
Message: DHCP per Port range (192.168.1.50 - 192.168.1.66) is not equal to switch TP port number (8).
To Next Page
Loading...
Need help?
General
