MacDon M205 - Setting the Cab Display Language

214603 120 Revision A
Setting the Cab Display Language
1007188
C###
X###
WINDROWER SETUP?
NO/YES
A
B
Figure 3.133: M205 Windrower Setup Display
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
1022053
C###
CAB DISPLAY SETUP?
NO/YES
X###
A
Figure 3.134: M205 Cab Setup Display
3. Press SELECT (A) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
1009976
DISPLAY LANGUAGE?
ENGLISH
C###
X###
D
C
A
B
Figure 3.135: M205 Language Display
4. Press right arrow (C) to select YES. Press SELECT (D).
• DISPLAY LANGUAGE? is displayed on the
upper line.
• Default language is displayed on the lower line.
5. Press left (B) or right (C) arrow to select preferred
language.
NOTE:
English, Russian, and Spanish language options are
available on windrowers. Not all language options are
available on all windrowers.
6. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
OPERATOR’S STATION