MacDon M205 - Adjusting Double Windrow Attachment (DWA) Draper Speed; Engaging and Disengaging the Double Windrow Attachment (DWA)

214603 214 Revision A
Engaging and Disengaging the Double Windrow Attachment (DWA)
The DWA system is engaged with controls in the cab.
1006160
A
B
Figure 4.94: Ground Speed Lever (GSL)
1022623
A
B
Figure 4.95: Operator’s Console
The deck is lowered and raised with the DWA DOWN (B)
and DWA UP (A) switches on the ground speed lever (GSL)
or with the rocker switch on the operator’s console,
depending on operator preference. The windrower cab
display module (CDM) is programmed during the installation
of the double windrow attachment (DWA) but the controls
can be swapped at any time. Refer to Activating the Double
Windrow Attachment (DWA), page 98. The draper is
activated during deck lowering and deactivated during
raising.
NOTE:
The same switch is used for raising and lowering a swath
compressor (if installed).
Adjusting Double Windrow Attachment (DWA) Draper Speed
1022640
A
Figure 4.96: Operator’s Console
The DWA draper speed is controlled with the rotary
switch (A) on the operator’s console.
OPERATION