MacDon M205 - Changing the Windrower Display Units

214603 121 Revision A
Changing the Windrower Display Units
1007188
C###
X###
WINDROWER SETUP?
NO/YES
A
B
Figure 3.136: M205 CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
1009975
C###
CAB DISPLAY SETUP?
NO/YES
X###
B
A
Figure 3.137: M205 Cab Display Setup
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? is displayed on the
upper line.
1009977
DISPLAY UNITS?
IMPERIAL
C###
X###
D
C
A
B
Figure 3.138: M205 Display Units
5. Press SELECT (D) until DISPLAY UNITS? is displayed
on the upper line.
• Default setting is displayed on the lower line.
6. Press left (B) or right (C) arrow to select either METRIC
or IMPERIAL speed display.
7. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
OPERATOR’S STATION