MacDon M205 - Adjusting the Cab Display Buzzer Volume

214603 122 Revision A
Adjusting the Cab Display Buzzer Volume
1007188
C###
X###
WINDROWER SETUP?
NO/YES
A
B
Figure 3.139: M205 CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
1009975
C###
CAB DISPLAY SETUP?
NO/YES
X###
B
A
Figure 3.140: M205 Cab Display Setup
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? is displayed on the
upper line.
1009978
BUZZER VOLUME
C###
X###
D
C
A
B
Figure 3.141: M205 Buzzer Volume
5. Press SELECT (D) until BUZZER VOLUME is
displayed on the upper line.
• Previous setting is displayed on the lower line.
6. Press left (B) or right (C) arrows to adjust buzzer
volume.
7. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
OPERATOR’S STATION