MacDon M205 - Testing the Reel Fore-Aft Activate Function Using the Cab Display Module (CDM)

214603 152 Revision A
1010039
ACTIVATE DWA DRV
D 0 P 0
- +
C###
X###
D
D
B
A
C
E
Figure 3.211: M205 DWA Drive
7. Press SELECT (E) until ACTIVATE DWA DRV is
displayed on the upper line.
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Do NOT overspeed the DWA drive.
Press and hold HAZARD (C) button.
• Press left arrow (B) to decrease DWA drive speed.
• Press right arrow (D) to increase DWA drive speed.
IMPORTANT:
Verify the DWA drive is functioning properly.
8. Release the HAZARD (C) button. The DWA drive
will stop.
9. Press PROGRAM (A) to exit programming mode or
press SELECT (E) to proceed to next ACTIVATE
FUNCTION.
Testing the Reel Fore-Aft Activate Function Using the Cab Display Module (CDM)
NOTE:
• The reel fore-aft function requires the completion kit for draper header reel drive (MD #B5496). For more
information refer to 7.3.5 Completion Kit for Draper Header Reel Drive, page 446.
• The header MUST be attached to windrower to perform this procedure. For more information, refer to 4.5
Attaching and Detaching Headers, page 217.
• The engine MUST be running to perform this procedure.
1007188
C###
X###
WINDROWER SETUP?
NO/YES
A
B
Figure 3.212: M205 CDM Programming Buttons
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? is displayed on the
upper line.
OPERATOR’S STATION