214603 180 Revision A
CAUTION
Operate both steering wheel and ground speed lever slowly while becoming familiar with the machine.
Remember that steering is more sensitive when speed-range control is in high road speed position. Avoid
the common tendency of new Operators to oversteer.
CAUTION
Check local laws for width regulations and lighting and marking requirements before transporting
on roads.
Before driving windrower on a roadway:
Figure 4.32: Header Drive Switch
1. Ensure HEADER DRIVE switch (A) is pushed to OFF
position (down).
2. Clean flashing amber lamps, red tail and head lamps,
and check that they work properly.
3. Clean all reflective surfaces and slow moving vehicle
emblems.
4. Adjust interior rear view mirror and clean windows.
Figure 4.33: Light Switches
5. Push LIGHT switch (A) to ROAD position to activate
lamps. Always use these lamps on roads to provide
warning to other vehicles. Refer to 3.7 Exterior Lighting,
page 49.
NOTE:
If the auto-road light feature is activated (i.e., windrower
is in engine- or cab-forward mode, out of park, high
range switch position, and header off), only the two
front corner field lights will turn on; the remaining field
lights are disabled.
6. Use HIGH/LOW LIGHTS (B) as required when other
vehicles are approaching.
7. Push BEACON switch (C) ON to activate beacons.
OPERATION
To Next Page
Loading...
